TTR-E
October 8, 2016
The TTR-E anchorage is made of an anchor plate equipped with bushes and wedges; the distribution under plate may be used for load transferring when the drilling hole does not match the plate diameter.
Latest
Anchorages
TTM and TTM-F
October 8, 2016
The TTM anchorage is made of an anchor plate, it is equipped with wedges and an under plate for load transferring. In the permanent version the anchorage is equipped with a protection cap. The anchorage can no longer be tensioned over time after wire strands are cut.
S Series
October 8, 2016
“S” series passive anchorages are produced in full accordance with the regulations in force. In this type of anchorage strands are open at the end to increase their adherence to concrete.
MX Series
October 8, 2016
Simulations made with finite element codes and laboratory tests allowed to design a compact anchorage to comply with the guidelines ETAG 013.
Mep Series
October 8, 2016
“Mep®” series active anchorages are designed for post-tensioning applications in an aggressive environment. They offer casting covered in epoxy-polyester coating as corrosion protection and polyethylene cap to protect the anchor block, all grouted with grease.
ME, MEep and MEX Series
October 8, 2016
“ME, MEep and MEX “ active anchorages are designed for external post-tensioning and may be supplied with several applications.
M Series
October 8, 2016
“M” series active anchorages are designed for traditional post-tensioning applications. They are used with galvanized or non-galvanized metallic sheaths or polyethylene sheaths. The whole device is then grouted with cement mix. They are provided with front grouting hole and threaded holes to connect with the formwork. They are provided with a rear polyethylene cone for connection to several-diameter sheaths.
Through Anchorages
October 8, 2016
Anchoring: active member, such as “1ED15-A18”, is made with the anchor strand and inserted in a polyethylene conduit, application environments where protection is required in the casting complex obtained by passivation.
Pre Block Anchorage
October 8, 2016
For use on slabs, preassembled cables can be supplied with the passive anchorage preblocked at one end, which are ready for the installation on site and assembled from factory.
Passive Anchorage
October 8, 2016
The anchorage: passive, unbonded and encapsulated, “1EX15-D2” type. It is made with the total encapsulation of the polyethylene covered anchorage, with the greased strand covered in polyethylene. The “1EX15-D2” anchorage is unbonded, it is supplied passive, factory prelocked or to lock on site by using a B300KN jack. This application is typical of industrial floors, foundation piles, diaphragms and slabs in a highly corrosive environment for the whole system.